In the process of prototype design, product components need to be modified, or information is input during molding, or information is attached to the prototype after molding, which needs to be described, refined and explained in their own sketches. Next, Jinan prototype manufacturer will analyze the product decoration content in the prototype design process.
If the manual board model is colored or its interior is colored, the color system must be determined. These colors are provided by resin or coating, such as an organic pigment added to the matrix resin, dye or color powder sample. The coating system must also be tested in the final product to ensure that the coating will not degrade the performance of the resin. Paint mixing ratio, if possible, its composition shall be provided by the Seller.
The harmful effects of some organic pigments on the physical properties of the matrix resin are not obvious when the content is low. Some people may need special plastics, and static electricity shall be eliminated before surface treatment and decoration. If you need special handling and preparation, you will need to draw in the planning and production drawings. Modify to increase the value of the standard model, but if you do not properly become defective, it will reduce profits, customer complaints.
The design and decoration of hand model can be completed in many ways, such as mold modification, coloring, decal, metal processing, electroplating, etc. The transformation work is usually completed in the factory, but more specific work, such as electroplating, metal processing is completed by external manufacturers. If it is carried out outdoors, the Seller shall be contacted to determine the modified operation requirements of surface treatment. Handboards may be included to meet special cleaning needs, or no treatment is required.
It often happens that if the modification method can cause the prototype to crack during the modification process, specific conditions need to be selected to reduce the molding stress of the product. This phenomenon is often seen when the plastic surface is metal treated. When they need to be etched with acid, if the molding stress in the product is too high, it will lead to the failure of the prototype production.
These specific problems need to be raised to ensure that specific conditions are selected for the prototype to be modified during the prototype design. At the same time, the modification processes that affect the materials and the prototype also need to be discussed, such as cleaning solution, solvent, etchant, dyeing drying time and temperature. The products to be modified from the standard production stack shall be subject to final application inspection as soon as possible after molding to ensure that the molding process does not cause stress in the molded products, which may cause problems in the modification process and final application process.
This is the end of the product decoration in the design process of the analysis prototype. If you have any doubts or needs, you can follow our website at any time http://www.szdgnt.cn Contact us, and the relevant personnel will serve you wholeheartedly!